PRODUCT DESCRIPTION. Fits: A, B, E Body. THIS TOOL FACILILTATES THE REMOVAL OR INSTALLATION OF THE UPPER CONTROL ARM BUSHINGS. TO PULL AN OLD BUSHING OUT, PLACE THE CYLINDER OF THE TOOL ON THE OUTSIDE OF THE CONTROL ARM, INSERT THE THREADED ROD AND TIGHTEN IT TO EXTRACT THE BUSHING.
TO INSTALL A NEW BUSHING. Jun 04, Here is an old school method that works well in removing your old worn out lower control arm bushings in your Mopar. Jun 02, These are the upper control arm bushings after removal with a cold chisel and a cut-off wheel.
They must always be replaced. Step This is how the upper control arm bushing looks after being pressed in at the machine shop.
Notice that on this car the upper arm is painted black. May 01, 6 BBL/Six Pack Member. Lift Off Hoods. Forever! Posts: Re: upper and lower control arm rebuild and detail. Reply #2 - 05/06/11 at On the uppers. I built my own"jack screws" out of all 1/2" all thead, washers, a few nuts and a couple of appropriate sized sockets to push them in/out with. Fairly cheap to do. May 18, Control arm bushings.
General Mopar Tech Discussions. Dec 10, #1. 69coronet Member. Messages: 8 Likes Received: 0. Joined: the upper ball joints. what thread are those. right handedd. May 18, For the lower control arm bushing, i used a propane torch to soften the rubber and pulled it out. Aug 05, Upper control arm bushing removal. Jump to Latest Follow 1 - 10 of 10 Posts.
Skraps Premium Member. Joined Aug 30, Posts. Discussion Starter #1. One method for removing stubborn rust incrusted bushing housing.